I have MCE running with Dish Network and can record shows with no problem,
but only if the show starts shortly after I turn off my TV. If the TV has
been turned off for a while, the satellite receiver goes into standby mode
and displays a "Dish Network" screen saver. Once I turn off the TV again, I
need to press teh "OK" button on the remote, otherwise I cannot even change
channel. Therefore the next day I have a one hour long recording of the
screen saver...
Is there a way to get the IR Blaster to send a "OK" signal before any
recording? Maybe a "OK followed by a "Cancel" would even be needed, because I
think that if the receiver is NOT in standby mode, pressing the "OK" will
show the channel information. Or is there a simpler solution to this?
Surely I am not the only one who wants to record shows in the middle of the
night on Dish Network...
Thanks,
Benoit